HUMMER H1: STEP BY STEP
10
11
77
88
22
33
Insert the stopper into the hole in the right
servo saver upper arm, as shown.
Engage the hexagonal
projection with the
corresponding recess
in the hole of the servo
saver, as shown.
Hold the servo saver
shaft and insert it into
the servo saver lower
arm. The stopper should
be oriented as shown in
the photograph.
Place the 3mm nut onto the end of the
stopper.
Tighten the nut onto the stopper with
your fingers.
Assembling the servo saver
11
11
66
99
44
10
10
55
Place the servo saver adjuster onto the servo
saver spring.
Remove the servo saver adjuster from the
servo saver shaft.
Turn the lower arm so it is at a right angle to
the upper arm and slot them together.
Check that your servo saver assembly now
resembles the one shown above.
Place the spring over the shaft and into the
recess of the lower servo saver arm.
Holding the end of the shaft with the
hexagonal projection, insert it into the servo
saver hole with the hexagonal recess.
