HUMMER H1: STEP BY STEP
3
11
22
On the rear of the front grill
are two pins (circled in dotted
red) below the headlight holes,
and there are two slots (blue
rectangles) below the pins. The
pins fit into holes (ringed in red)
and the projections (dotted blue
rectangles) fit into the slots on
the grill. Test-fit these two
parts together.
This stage of assembly is now complete. At the end of every stage, you
should store all parts safely for later use.
If you find the fit is too tight, don’t force the parts together: file the top and bottom
sides (outlined in red, above right) of the projections on each side of the grill mesh
with a file or wet and dry paper (800 grit). Be careful not to file this part too much, as
it may become weak.
Assembling the
front grill
Now tighten the screws
into the holes evenly,
tightening each screw a
little at a time, and working
repeatedly around the gear
until all the screws
are secure.
Your 46T gear assembly
should now look like this.
10
10
99
What does the ‘T’ stand for
in ‘46T’?
The letter ‘T’ in 46T stands for teeth. And the
number before the T, in this case ‘46,’ specifies the
number of teeth that the gear has. All the gears
supplied in this series are named in this way.
22
Tip
This step is to just familiarize you with
how the parts fit together, so don't glue
them at this stage.
Assembled parts
