HUMMER H1: STEP BY STEP
18
11
11
33
55
22
22
44
66
Place the 1510 ball bearing over the projection on the
differential case.
Cut a corner from the grease bag and place a small amount of
grease onto the end of a toothpick, or similar.
Apply some grease to
the differential cup joint.
Insert the joint into the
hole, slowly rotating it
back and forth to spread
the grease.
Place the end of the
joint into the hole of
the projection on the
inside of the bearing.
Place the 6mm O-ring
over the joint on the
inside of the case.
Press the bearing firmly into position on the projection. Make
sure the bearing is aligned with the case.
Apply some grease to the recess in the center of the inside of
the differential case.
Fitting the bearing onto the differential case
Assembling the differential gear
