G E K O
EN
15
5.2 Control board standard programming
1
Power Supply
Give power supply, the display shows the following symbols “
”, “
”, “
” and then “----”
2
Messages concerning working status
1. Press on the key;
2. Check that the display shows the correct outputs status.
3
1 or 2 operators operating selection
1. Scroll down the parameters until you visualize P020;
2. Confirm by pressing on the key;
3. By pressing on and , keys, set up:
- d001=for 1 operator mode;
- d002=for 2 operators mode;
4. Confirm by pressing on the
key (display shows again
P020).
4
Learning of operators stroke
4.1 Positioning leaf 1
1. Scroll down the parameters until you visualize P001;
2. Confirm by pressing on the key;
3. By pressing
(open) and
(close) keys
(if this does not
happen, you must swap the two motor 1 cables)
, position
leaf n.1 in its standstill position while opening;
4. Confirm by pressin on the key (display shows again P001).
4.2 Positioning leaf 2 (only for 2 operators)
1. Scroll down the parameters until you visualize P002;
2. Confirm by pressing on the key;
3. By pressing (open) and keys
(if this does not happen,
you must swap the two motor 2 cables)
, position leaf n.2 in
its standstill position while opening;
4. Confirm by pressing on on the
key (display shows again
P002).
Summary of Contents for GEKO
Page 71: ...G E K O 69 ...
Page 75: ......
