264
265
Assembly Guide
264
265
3
4
Hold one of the motors drivers as shown and plug it into the position for the Z-axis motor driver (see
previous page, Step 2). Make sure that the circular structure on the driver is aligned as shown above.
Hold the driver parallel to the driver board while you plug it in slowly and firmly until it is in all the way.
Now plug the other motor driver into the position for the feeder motor driver. Again, press
firmly while holding it parallel to the driver board until it is fully inserted.
Plug the motor drivers into the driver board
Ensure the driver motors are not
at an angle to the driver board and
that the pins are all the way in.
Make sure that the
circular element on
the top of the motor
driver is on the left when
viewed with the front of the
housing facing you.
Be careful not to touch
this element.
Make absolutely certain that
the motor drivers are correctly
plugged in, with their pins in the
correct sockets and the circular structures
to the left.
Failure to
do so might
result in
fire during
operation of
the printer.
Circular element
Attach the feeder cable to the housing, then plug it into the driver board
5
6
With a marker pen, make a mark on the
feeder motor cable 12cm in from the end
of the cable, measuring from the smaller
(motor end) connector.
Turn the housing so the rear panel is facing you. Put a cable tie through each of the four
sets of holes outlined in red in the image above left. Align the tie at the top right with the
mark on the feeder motor cable and, with the motor end socket on the right, tighten the
cable tie around the cable. Trim off the excess cable tie with scissors.
Align with
12cm mark
CAUTION!
CAUTION!
