278
279
Assembly Guide
278
279
Stage 45: Add a second
linear bush to the table
In this stage, the linear bush is put through
a hole in the top left of the table, before
being secured in place with the four
cap head bolts supplied with this stage.
Remember that when putting the washers
onto the shaft of a bolt, the M3 flat washer
goes on
before
the spring washer. The
spring washer is followed by the nut.
When you have secured the bush with
the nuts, tighten the bolts using the 50 x
2.5mm Allen key supplied with Stage 44.
Lastly, check and adjust the alignment
of the metal dog, which is next to the
newly-added linear bush.
Parts to have ready
1
Get ready the table you
worked on in Stage 44.
1:
Linear bush x 1
2:
M3 cap bolts (15mm) x 4
3:
M3 spring washers x 4
4:
M3 flat washers x 4
5:
M3 nuts x 4
Stage 45 Components
This assembly is much the same as part of that in the previous stage (Stage 44), where
you added a linear bush to the table base, fastening it in place with four cap head bolts.
Remember to make sure the bush is the right way up in its hole in the table.
You will need
Allen key (50 x 2.5mm) supplied with Stage 44
Stage 45 Assembly Area
1
2
3
4
5
