DAYLIFF DGW 200P, Installation & Operating Manual

Page: 11 / 28

8
Cover
Check Diesel Welding Machine
Ÿ Turn off the main switch and any other loads such as the light and motor switches.
AC Output
DC Output
Starting
Switch
Circuit Breaker
Voltmeter
Ÿ Be sure to turn off the main switch before starting the generator. If the switch is not on
the ‘OFF’ position, sudden application of load could be very dangerous when the
diesel engine is started.
Ÿ The generator should be earthed to prevent electric shocks.
Handling of dual voltage type diesel welding machine
Operation of change over switch
Ÿ
The circuit breaker on the control box must be used whenever AC power is to be used
and must be set to ‘OFF’ position before running the machine.
Ÿ
Start the genset and upon attaining the rated speed turn the switch to ‘ON’ position.
Ÿ
The two sockets are ready to be used for output of rated voltage.
Ÿ
Set the main switch at ‘OFF’ position when using 12V power for charge.
Ÿ
The terminal of 12V output can be used for 12V voltage charge user can provide a
charge switch for switch on and off.
Bleeding Fuel Line
Ÿ Check fuel pipeline to find out whether there is air mixed into the pipeline. If yes, drain
away the air from the pipeline before refueling and start the diesel engine.
Ÿ To do this, loosen the connection nut between injection pump and pipe line and then
drain off the air until no air bubble comes from the fuel.
Low Oil Warning System/Stop Device
Ÿ
This device works to stop the engine automatically when the oil pressure falls below
the recommended level and to prevent engine seizure when lube oil is running short
Ÿ
The oil temperature will rise too high if the engine is operated with insufficient
lubrication oil.