7
D
2
4
Installing the device
The ergometer should be installed on a rigid floor (e.g. concrete floor).
For other types of floor we recommend using a protective underlay. Ap
-
propriate floor protection mats can be ordered from daum electronic
gmbh. The manufacturer shall not be liable for any damage done to the
floor. Order No.: 0810402
To ensure the safety of the user you must leave a safety clearance area, of
at least 2 m in length and 1 m in width, behind the treadmill. In order to avoid
injuries this safety clearance area should be covered by a soft exercise mat or
any similar furniture. The location of the device must be level (flat) and clean.
The device must be installed in a horizontal position and may not “wobble”.
The feet must be adjusted accordingly and must absolutely have a steady
contact with the floor.
It is not intended for use in rooms with damp conditions. This could cause rust
to build up on the ergo_run, which would damage device parts and impair both
the operating functions and the safety features.
The load carrying capacity of the ceiling / floor in the building must at least be
equal to 600 kg / square meter. If in doubt consult a building stress analyst.
The tension of the running belt must be checked upon installation or whenever
the device is moved from one location to another, and adjusted as needed
(see the maintenance chapter).
The treadmill may only be connected to the power supply and put into opera-
tion when the above conditions are satisfied; connect it by plugging its power
cable to an appropriate power socket (see connecting the device).
The ergo_run functions with a mains voltage of 230 Volt, 50 Hz and has a
power consumption of 2000 Watt. The power supply you wish to use must
satisfy these requirements!
Before proceeding with the assembly please make sure that
the mains plug is pulled out!
Transport and packaging
The manufacturer and the dealer will not be held liable for
damages occurring during the transport and for missing
parts.
Therefore please check the packaging and its content ca-
refully upon receiving of the device. Complaints related to
transport damages will only be accepted by the transport
insurance if they are immediately recorded by writing on the
delivery documents of the freight forwarder.
Please address any complaints to daum electronic gmbh.
In general daum training devices are delivered by a forwarding company.
Daum electronic gmbh is a member of the organisation: “Der grüne Punkt –
Duales System Deutschland GmbH.”
Please proceed with the unpacking of the device and accessories as descri-
bed in the user manual. Please make sure that the device and accessories
are not damaged, that small parts are not inadvertently misplaced, and that
connection cables are not damaged.
Please dispose of all packaging material in a safe way. Keep all foil and plastic
bags away from children
-
suffocation risk.
If in doubt, ask another person to help you with the installation.
Heavy equipments may only be transported by authorised
personnel and under compliance with the relevant safety
regulations. Otherwise a serious risk exists for the persons
and machine.
!
!
!
3
Installing the device
Release the immobilising belt.
1
Release the cable tie.
Open the bottom box.
Pull/raise the device carefully.
3.1
Moving the device: attach the belt, lift the rear of
the device and move it on its wheels.
Installing and starting
GB
