30
Adjusting the running belt
After an extended period of use, check for the existence of slip between the
driving shaft and the belt. To do this stand on the belt running at slow speed,
hold firmly the crossbar of the console with both hands and press your feet
against the running direction to block (immobilise) the belt. If at this moment
the driving shaft still revolves then the belt tension must be adjusted.
Turn the tension screws (Allen wrench no 6) equally alternating on both sides,
until you obtain the required belt tension.
Centring the running belt is carried out at a speed of 7 km/h.
Turn the right or left side screw according to the position of the belt.
Turn right side screw clockwise to move the belt to the left, counter-clockwise
to move the belt to the right.
Turn left side screw clockwise to move the belt to the right, counter-clockwise
to move the belt to the left..
The centring operation is complete when the belt remains in the centre of the
roller for an extended period of time.
Lubrication of the running belt / sliding plate
Take care not to touch the running belt. Ask another
person to stand with you, ready to push the EMERGENCY
STOP button if something arises during this maintenance
process.
A lubricant is applied by the manufacturer between the running belt and the
plate underneath it. This lubricant must be renewed depending on the fre-
quency of use.
Use for this only the supplied special silicone oil lubricant!
Other lubricants or greases could damage the running belt and the running
surface and consequently lead to a failure of the running belt. Order the spe-
cial silicone oil lubricant from daum-electronic gmbh.
At the very latest lubricate the running belt every 1000km or when you hear
dry rubbing noises while running.
If too much silicone-oil is applied it could lead to an acceleration effect on the
running belt under the weight of the user with high inclination values.
Remove the covers on the ends of the running belt and spray regularly on the
inner side of the belt running at a speed of 3 km/h.
Damages resulting from lack of care or lubrication of the running belt are not
covered by the warranty.
!
Contacting your dealer
If the cause of the failure could not be identified, you should contact the
dealer, where you bought the machine, or daum electronic gmbh.
We need the following information:
1.
The device serial number (this number is on a silver label
underneath of the power ON/OFF switch).
2.
The dashboard software version number (you can access this
number under the menu item “Menu” - “Information” - “Version” –
“Software”).
3.
The proof of purchase and the device reference sheet.
If you wish to obtain more information on your device, please visit our ser-
vice and repair hints site on Internet (www.daum-electronic.de).
Glass tube fuse 5x20 T10A H
The fuse is located close to the power switch (ON/OFF) on the lower front
part of the treadmill.
Defective fuse:
The green ON/OFF switch does not glow upon switching it to the ON posi-
tion.
The machine does not start.
The power cord was verified.
Unplug the power cord before replacing the fuse!
Replacing the fuse:
- Unscrew and remove the black fuse holder (close to the ON/OFF switch).
- Replace the glass tube fuse 10A /250V
- Reinstall and screw the fuse holder.
- Plug the power cord into the power outlet.
!
Maintenance
