Datcon DT9502, Operating Instructions Manual

Page: 74 / 92

DT9502
74
20171205-V3
Limit output sub-menu
In the menu, the second menu-item (

) contains all
the parameters that relate to the limit output No.1.
When you enter the menu, you get into a sub-menu.
The menu structure is presented by the figure
7.2. Menu
structure .
The items within the sub-menus are not numbered. Instead,

is used showing that all the menu items that constitute
the sub-menu in question belong to the limit output No.1.
This prevents you from mixing it up with the main menu.
Sub-menu items You will find a detailed description of the limit-value sub-
menu items in the following text.

Operating mode ( S etting s )
It defines the conditions under which the limit output should
switch ON depending on the value of the measured and
displayed physical signal. [Default factory setting: OFF]
Detailed description: on the following page

Low limit value ( L ow L imit)
It is one of the numerical values, to which the instrument
compares the measured signal continuously. [Default
factory setting: 0]

Lo limit value hysteresis ( H ysteresis for L L)
This is the half of the hysteresis value that belongs to the
low limit value. [Default factory setting: 0]

High limit value ( H igh L imit)
It is the other numerical value, to which the instrument
compares the measured signal continuously. It’s value must
not be lower that the value of

. [Default factory
setting: 0]

High limit value hysteresis ( H ysteresis for H L)
This is the half of the hysteresis value that belongs to the
high limit value. [Default factory setting: 0]

Alarm mode ( A larm M ode)
[Default factory setting: OFF]
Detailed description in the chapter:
Alarm Mode .