Datcon DT9502, Operating Instructions Manual, Page: 67 / 92

DT9502
20171205-V3
67
10.5. Description of the menu items
You find a description of the menu items in the following
part. A description on the handling of the menu is in Chapter
7. Settings .

Display modes of limit output status ( L imit D isplaying)
[Default Factory Setting: OFF]
•

Switched off ( OFF )
It never displays the limit output status.
•

Dynamic button ( D ynamic B u t to n )
As long as the ENTER is being pressed down.
•

Timed button ( T imed B u t to n )
As long as the ENTER is being pressed down + for 2.5
seconds.
•

Static button ( S tatic B u t to n )
The display can be switched ON/OFF by ENTER .
•

Automatically: when changes ( Au to: C hang e )
For a period of 2.5 sec, after a change has taken place in
the output. Disabling: by
ENTER
•

Automatically: periodical ( Au to: P eriodica l )
Periodical: ON/OFF in each 2.5 seconds. Disabling: by
ENTER .
•

Always ON ( ON )
Disabling: by ENTER .

Limit output configuration sub-menu No.1. ( L imit 1 )
Detailed description in the chapters 7.3. , 7.4. , 7.5.

Limit output configuration sub-menu No.2. ( L imit 2 )
It is the same as for limit output No.1., but everything
pertains to limit output No.2. Detailed description in the
chapters
7.3. , 7.4. , 7.5.

Access is possible
by supervisor code only
4 wiring / 3 wiring measuring metod (W ir E)
Must set to conformable with effective swathe metod Pt 100.
[Default factory setting: 4 wiring.]

Access is possible
by supervisor code only
The temperature value belonging to 4 mA
Any value may be assigned to it within the temperature
interval displayable on the display [Default factory setting:
-200.0 °C]