DT1012 IP
20221107-V0
15
5.3. Connecting the current output to the signal processor unit
The following figure shows the wiring plan, connecting the passive
current output to the signal processing unit:
Wiring plan, connecting
the current output to
the signal processing
unit
Be careful the polarity of
the cables
Leave connection
terminals 3 and 4 free!
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to the wiring
plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on them firmly.
Checking the
connections
Check if the cables are connected properly (have you connected all
the cables, have you connected to the right place, do not the cable-
ends touch each other).
