DT1012 IP
20221107-V0
27
7.3. Analogue output setting
Function
Used to set the analogue output parameters as:
Analogue output type: 4-20mA / 0-20mA / 0-10V / 0-5V / 2-10V
Error indication: None / Yes
Location of error indication (for 4-20 mA): below 4 mA / above 20 mA
Lower scale value
Upper scale value
[Factory defaults: see figure below]
Setup steps
1. Click the "Analogue” button in the ”OUTPUT” field.
2. In the window that appears, make the necessary settings.
3. Store the settings by clicking the "Write to instrument" button
4. Close the settings window by clicking the "Exit (Esc)" button.
Until you close one setting window, you cannot open another!
The following figure shows the factory default settings:
