DataMetrics 2000 Series, Operation And Maintenance Manual

Page: 44 / 46

MODEL 2000 PRINTER OPERATION AND MAINTENANCE
DataMetrics Corporation 36
b. External paper feed configuration only: Position the circuit breaker cover on the inside
of the front panel. Install the hardware that secures the cover.
c. Install the AC LINE, AC NEUTRAL, and CHASSIS GROUND terminals of the circuit
breaker harness on the power supply terminal block.
d. Connect the CHASSIS GROUND terminal of the circuit breaker harness to the inside
of the rear panel.
e. Install the AC LINE and AC NEUTRAL terminals of the circuit breaker harness on the
line filter output (bottom) connections.
f. Position the line filter on the chassis and install the hardware that secures the filter.
g. Install the line filter cover on the chassis.
h. Close the top cover of the printer.
6.5.5. Line Filter
Removal:
a. Open the top cover of the printer.
b. Remove the hardware that secures the line filter cover to the chassis. Remove the
cover from the chassis.
c. Remove the hardware that secures the line filter to the chassis.
d. Remove the input, output, and ground harness terminals from the line filter. Remove
the line filter from the chassis.
Installation:
a. Install the AC LINE, AC NEUTRAL, AND CHASSIS GROUND terminals of the power
input harness on the line filter input (top) connections.
b. Install the AC LINE and AC NEUTRAL terminals of the circuit breaker harness on the
line filter output (bottom) connections.
c. Position the line filter on the chassis and install the hardware that secures the filter.
d. Install the line filter cover on the chassis.
e. Close the top cover of the printer.
6.5.6. Controller Board
Removal:
a. Remove the print engine assembly per 6.5.2.
b. Remove the power supply, control panel, and parallel interface cables from the
controller board.
c. Remove the hardware that secures the controller board to the print engine base plate.
Remove the controller board from the chassis.