DataMetrics 2000 Series, Operation And Maintenance Manual

Page: 19 / 46

MODEL 2000 PRINTER OPERATION AND MAINTENANCE
DataMetrics Corporation 11
3. INSTALLATION
3.1. Introduction
This chapter provides information and instructions required for installation of the Model 2x00
printer. Information is included concerning unpacking, ribbon and paper installation,
connection of external cabling, software installation, setup utilities, and storage.
3.2. Chassis Installation Configuration
Model 2100 (rack mount) chassis outline dimensions are identified in Figure 3-1.
Model 2000 (tabletop) dimensions are identified in Figure 3-2. The mounting footprint for
the tabletop configuration is shown in Figure 3-3.
3.3. Unpacking
Follow the steps listed below to unpack the printer and prepare the unit for installation.
Packing materials should be retained for future use.
a. Carefully remove the printer from the shipping container. Inspect the unit for any
evidence of damage.
b. Open the top cover of the printer and remove the plastic retainer from the printhead
carriage guide bar.
3.4. Ribbon Installation
Follow the procedure defined below to install a ribbon cassette in the printer. Refer to
Figures 3-4 and 3-5.
a. Open the top cover of the printer and power up the unit to center the ribbon carriage.
b. Adjust the head gap lever to the “6” position.
c. Rotate the knob on the ribbon cassette clockwise to remove any slack.
d. Position the ribbon cassette over the printhead. Angle the ribbon cartridge down and
position it under the retaining bracket. Ensure that the ribbon is located between the
printhead nose and the ribbon mask. Gently press down on the cassette until it snaps
into place.
e. Adjust the head gap lever for the thickness of paper used {1 (thin) to 6 (thick)}. A head
gap setting of 2 or greater is recommended for normal operation.
f. Close the top cover of the printer and power down the unit (if required).
3.5. Paper Installation
Follow the procedure defined below to install paper in the printer. Refer to Figures 3-4 and
3-5.