Datamax M-Class M-4206, Operator'S Manual

Page: 104 / 168

94 M-Class
Printer Fault Messages
(continued)
Displayed Message Description Possible Solution(s)
!
HBQ!NPEF!
GBVMUZ!TFOTPS!
!
Consistently high sensor
readings were detected.
Press any key to continue. Ensure that media was removed
from the media sensor during the appropriate calibration
steps; also ensure that no labels are stuck in the media
sensor. Retry the calibration. If the problem persists, call for
service.
!
!
PVU!PG!TUPDL!
!
The printer can not detect
media. Try the following:
1) Load media.
2) Ensure that the labels are passing through the Media
Sensor.
3) Readjust the Media Sensor over the TOF mark; see
Section 3.3.
4) If using media with large gaps, adjust the Paper Out
Distance; see Section 5.1.2.
5) Calibrate the printer; see Section 5.4.
!
!
QPTJUJPO!GBVMU!
Two possible causes:
(1) The printer was
powered-off or reset during
a ribbon, out of stock or
TOF fault; or (2) the printer
was unable to complete the
Media Calibration.
Depending upon the cause:
(1) Press the FEED Key in an attempt to identify and then
clear the related fault condition; or (2) if necessary, calibrate
the printer; see Section 5.4.
!
!
QSJOU!FOHJOF!GBVMU!
The printer has detected a
problem within the print
logic. Try cycling the printer power ‘Off’ and ‘On’. If the fault
does not clear, call for service.
!
!
SBN!GBVMU!
The system has detected a
RAM failure. Try cycling the printer power ‘Off’ and ‘On’. If the fault
does not clear, call for service.