Chapter 4 – Menu System
54
Diagnostics
The Diagnostics menu contains testing functions and printhead reporting selections:
Hex Dump Mode*
Options Testing*
Print Test Rate (min)*
Sensor Readings*
Ribbon Sensor Limits*
iPH Report*
Flash Module Report*
Items denoted with an asterisk (*) are only accessible through the Advanced Menu.
The menu selections are defined as follows:
DISPLAYED ITEM
ITEM DESCRIPTION
HEX DUMP MODE
Determines how the printer handles the data received from a host, where:
ENABLE
The printer outputs the raw ASCII data it receives without interpretation; no
processing occurs.
DISABLE
Processes data normally. (Default Setting)
FILE CAPTURE
Saves the incoming data to Module H (USB thumbdrive) if present; otherwise, the
file is stored on Module G. The file name, in the form [
dmx_xxx_yyy.dpl],
where
the count is automatically incremented for every capture and a unique printer time
stamp (xxx), is assigned.
OPTIONS TESTING
Performs printer option diagnostics or monitors and outputs test results, where:
TEST PRESENT
SENSOR
Performs a functional test of the Present Sensor by indicating LABEL PRESENTED
(when a label blocks the sensor) and LABEL NOT PRESENTED (when no label
blocks the sensor). (Note that this test can also be used to check the sensor
function of the Peel & Present option.)
TEST CUTTER
Performs a functional test of the Cutter, where:
PERFORM
TEST
001 TIMES
Cycles the cutter blade a selected number of times (0 - 999), with PASS / FAIL
results given for each cycling attempt.
TEST GPIO
Performs a functional test of the GPIO port, where:
MONITOR
GPIO INPUT
Displays input signal logic values for Start of Print (SOP).
If unconnected, a zero or one may be displayed.
TEST GPIO
OUTPUT
Displays output signal logic values for End of Print (EP) and Service Required (SR).
To change an output signal state, cursor over the displayed state
to select and then toggle it using the UP or Down Arrow Buttons.
PRINT SIGNAL
INFO
Prints a reference label containing GPIO signal names, pin assignments,
programmed settings, and current signal states.
PRINT TEST RATE
(MIN)
Sets a label-to-label delay interval (0 - 120 minutes) when Test label batch
printing, where:
000
Is the Default Setting.
Summary of Contents for I-Class Mark II I-4212E/203
