Datamars B500, User Manual

Page: 64 / 144

64
Installation
Mounting the energizer
The energizer can be mounted directly onto a steel T-post or Y-post using the
mounting slot in the case rear.
Mounting slot
Back of the
energizer
Alternatively, the energizer can be mounted onto a wooden post, another suitable
vertical support or suitable wall material using the two 75 mm (3") nails and two
washers provided. Thread washers onto the nails. Space the nails 75 mm (3") apart (or
one nail length). Hammer in the nails, allowing them to protrude by 10 mm (3/8").
Slide the energizer onto the nails with the washers inside the mounting slot.
Note:
If the energizer is being mounted on a wall made of concrete, brick,
plasterboard or similar, use screws instead of nails. Wall anchors or plugs may also be
required.