![background image](http://html1.mh-extra.com/html/datalogic/tc1200/tc1200_reference-manual_4199290133.webp)
REFERENCES
121
5
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure.
Serial Start
The Serial Start string (max 20 characters), signals the beginning of the reading phase.
Selections: characters from NUL (0x00) to ~ (0x7E).
NOTE
The ACK Character must be different from the NAK Character and must not
contain reserved characters (see
Appendix D
). Setting to previously defined
characters such as XON, XOFF, or host commands conflicts with normal
operation of these characters. 8-bit data is not recognized when the option
Data Bits
has been set as 7 Data Bits.
To set this feature:
1.
Determine the desired character string (max 20).
2. Use the Chart in
Appendix C
to find the hex equivalent(s) for the desired character(s).
3. Go to
page 48
and scan ENTER/EXIT PROGRAMMING MODE to enter Programming
Mode.
4. Scan the barcode: SELECT SERIAL START CHARACTERS.
5. Scan the hex equivalent characters from the keypad in
Appendix B
that represent the
desired character string in step 1 above.
6. If less than the expected string of 20 characters are selected, scan the ENTER/EXIT
barcode to terminate the string.
7. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure.
Serial Stop
The Serial Stop string (max 20 characters), signals the end of the reading phase. Selections:
characters from NUL (0x00) to ~ (0x7E).
NOTE
The ACK Character must be different from the NAK Character and must not
contain reserved characters (see
Appendix D
). Setting to previously defined
characters such as XON, XOFF, or host commands conflicts with normal
operation of these characters. 8-bit data is not recognized when the option
Data Bits
has been set as 7 Data Bits.
To set this feature:
1.
Determine the desired character string (max 20).
2. Use the Chart in
Appendix C
to find the hex equivalent(s) for the desired character(s).
3. Go to
page 48
and scan ENTER/EXIT PROGRAMMING MODE to enter Programming
Mode.
4. Scan the barcode: SELECT SERIAL STOP CHARACTERS.
5. Scan the hex equivalent characters from the keypad in
Appendix B
that represent the
desired character string in step 1 above.
Summary of Contents for TC1200
