Datalogic Arex 30W, User Manual

Page: 25 / 96

TECHNICAL SPECIFICATIONS
25
2
14 RESERVED Digital Input DO NOT CONNECT
15 RESERVED Digital Input DO NOT CONNECT
16 RESERVED Digital Input DO NOT CONNECT
17 END Digital Output
This signal is used to know if the marking process is
finished: (see paragraph 2.4.2.4):
- ON at the end of marking process
18 POWER_ON Digital Output
This signal is used to know if the system is already
warmed up: (see paragraph 2.4.2.3)
- ON when the laser is in STAND_BY or READY state
19 GND Ground Ground reference
20 SYSTEM_ALARM Digital Output
This signal is used to know if the system is in booting up
state or in error state: (see paragraph 2.4.2.3)
- ON during BOOTING UP
- ON in case of system error
21 GND Ground Ground reference
22 ENABLE_OUT Digital Output
This signal is used to know if the system is ready to emit
laser radiation: (see paragraph 2.4.2.3)
- ON when the system is in READY state
23 SW_READY (*) Digital Output
This signal is used to know if a document, sequence or
script is loaded and ready to be executed:
- ON when a document or a sequence is running in
AUTO MODE (**) or WORK MODE (**) (SW_READY
COMPATIBILITY (**) = true)
- ON when a document or a sequence is running in
AUTO MODE (**) and laser in READY state
(SW_READY COMPATIBILITY (**) = false)
- ON when a script is running n AUTO MODE (**) and
“IoPort.setReady (true)” function is used
24 GND Ground Ground reference
25 GND Ground Ground reference
(*) refers to Lighter user’s manual “Setting I/O parameters” paragraph to set the signal properties
(**) refers to Lighter user’s manual
(***) refer to paragraph 2.5
NOTE:
Connection example in paragraph 2.6.