DataKinetics DSC110 / DSC210 User Manual Issue 12
Page 143
7.23.8 Routing Outgoing Route Initiate
RTORI
Routing Outgoing Route Initiate
This command is used to initiate a route.
Syntax
RTORI: OGR=,{[HUNT=],[ANNC=]}
[CDST=,][CDDL=,][CDPRE=,][CGMD=,][CGDL=,][CGPRE=,][CPCD=,]
[CPCG=,][CG2PRE=,][CG2DL=,][LCMD=,][[NEXT=,][CDMD=,][LSTAB=,]
[LSM=,][ISTAB=,][ISM=,][CHG=,][TANS=,][BWM=,][IBI=,][LABEL=,];
Prerequisites
The outgoing route has not already been initiated and cannot have a value of 0.
The start moment must be greater than or equal to the number of called party
number delete digits.
If the hunting algorithm indicates circuit mapping no next route index can be given.
ISM can only be set to a value other than 0 if ISC is set to Y by CNSYS command.
If specified the next route must already have been initiated.
If specified the announcement must already have been initiated.
If an announcement is specified no next route index can be given.
If specified the routing chain that follows from the next route cannot eventually lead
to the outgoing route.
If the local service mode is greater than 0 then the local service control table must
also be greater than 0. If the calling party number mode equals 0 then the local
service control table must also equal 0.
If specified the calling party number profile must already have been initiated.
If specified the called party number profile must already have been initiated.
N.B. If HUNT is specified as well as ANNC the converter will first search for an
available circuit before playing the announcement. If only ANNC is specified the
announcement will play immediately.
N.B. When an outgoing circuit group from a route is Japan TTC ISUP and CG2PRE
is set the digits from the CG2PRE will form the carrier information code sent in the
IAM. The user should not set CGMD=2 when the route goes to an outgoing Japan
TTC ISUP circuit group.
Attributes CONFIG
Example RTORI:OGR=16,HUNT=1,CDST=5,CDDL=3,CDPRE=01425;
