DataKinetics DSC110 / DSC210 User Manual Issue 12
Page 141
7.23.5 Routing Hunt Sequence Initiate
RTHSI
Routing Hunt Sequence Initiate
This command is used to specify the order in which groups are to be considered to
belong to an outgoing route. The significance of this order (the hunt sequence)
depends on the hunt mode selected.
Syntax
RTHSI:OGR=,HTSEQ=,CGRP=;
Prerequisites
The outgoing route has already been initiated.
The specified Circuit Group has already been initiated.
For circuit map hunting only 1 circuit group can be assigned to a route and when
assigned it must be assigned to sequence number 1.
A circuit group cannot be specified in more than one hunt sequence position.
The outgoing route/hunt sequence combination must not already be initiated.
If the outgoing route is circuit mapped then the circuit groups involved must be
blocked.
Hunt sequences cannot be initiated if the outgoing route has no hunt mode.
Attributes CONFIG
Example RTHSI:OGR=4,HTSEQ=1,CGRP=56;
7.23.6 Routing Hunt Sequence End
RTHSE
Routing Hunt Sequence End
This command is used to clear a hunt sequence number of a circuit group.
Syntax
RTHSE:OGR=,HTSEQ=;
Prerequisites
The specified route index has already been initiated.
There is a circuit group attached to the hunt sequence number.
If the hunt sequence is involved in circuit mapping then it can only be ended if the
circuit groups involved are blocked.
The outgoing route/hunt sequence combination must already be initiated.
If the outgoing route is circuit mapped then the circuit groups involved must be
blocked.
Attributes CONFIG
Example RTHSE:OGR=4,HTSEQ=1;
