Datacolor Ahiba Ahiba MULTIPRECISE TC, User Manual

Page: 76 / 103

ahiba 75
AHIBA MULTIPRECISE TC - Dose Verification Menu
DOSE VERIFICATION
RINSE 0ml
DRAIN 0ml
CALIBRATE
DOSE VERIFICATION Menu to verify calibration result. Enter desired
volume and press [Enter].
DOS VOL 0.0ml
EXECUTE
RINSE 0ml Used for rinsing dosing tube or fill (prime) the tube
with water. After entering the desired volume and
pressing [Enter], a confirmation menu will appear.
TIP:
Always perform this rinse at the end of the day. This action will
prevent chemicals from crystalizing in the dosing tubes and
dosing pump diaphragm thus prolonging the life of the dosing
pump.
DRAIN 0ml Used for draining the remaining liquid in the tube.
Key in the desired volume and press [Enter]. The
total volume in the tube is approximately 6ml.
CALIBRATE Menu for calibrating the dosing pump.
TIP:
If more than one dosing is in a process, select one solution for
calibration. However during Dose Verification as above, test all
dosing solutions for accuracy. There may be a slight difference
in the volume due to solution concentration and viscosity. If the
difference is out of the required tolerance, adjust the dosing
volume during programming to compensate.