Datacolor Ahiba Ahiba MULTIPRECISE TC, User Manual

Page: 29 / 103

28 ahiba
AHIBA Multiprecise TC – Water Supply and Drain Connections
• Place the Ahiba Multiprecise TC on a sturdy / level table.
Note: Allow a minimum of 6 inches between the back of the unit and a
wall to allow space for hoses. Choose a location in such a way that
occurance of heat backup and for direct sunlight will be avoided.
• Connect the [1] warm water inlet, [2] cold water inlet, and [3] drain hoses (see the
following page).
Use only filtered, softened cooling water <10°dH !
Water filters (part number 942332) are available from Datacolor.
The water pressure must be 5 bar (72.5 psi) or less, no less than 2.5 bar
(36.25 psi). The water pressure must be consistant in order to achieve
accuracy during a water fill. If pressure flu/-2 psi (.14 bar) it is
recommended that pressure regulating valves be installed on the hot and cold
incoming water lines. Pressure regulating valves can be purchased from
Datacolor #62-500048. Valves should be set for minimum pressure.
The cooling water temperature should be < 20°C (68°F).
The tube from the drain outlet (3) must be installed so that human contact with
discharging water is impossible. (danger of burnings) !
Shown with dosing option