DAPAudio ZPA-6240TU, Manual

Page: 10 / 24

9
ZPA-6240TU
Ordercode: D6180
Backside
Fig. 02
100V terminal connector – IN
Connect the main feed cable from your 100V speaker to the “hot” terminal. Connect the common
cable from your speaker to the “cold” terminal.
NOTE: Do not connect the 100V and 4Ω speakers at the same time.
100V terminal connectors – OUT
Connect the main feed cable from your 100V speaker to the “hot” terminal. Connect the common
cable from your speaker to the “cold” terminal.
Low impedance 4Ω terminal connector
If you connect a low impedance speaker, then connect the main feed cable to the “hot” terminal
and the common cable to the “cold” terminal.
NOTE: Do not connect the 100V and 4Ω speakers at the same time.
Telephone ringer terminal connector – IN
Connect a telephone for calling and audio input
Paging terminal connector – IN
Connect a telephone for calling and audio input
Message first priority terminal connector
Connect an emergency alarm source.
External amplifier connector – 6,3 mm jack IN
Connect an external amplifier. When connected, all the other input signals will be suppressed.
Paging connector – 6,3 mm jack OUT
Connect an external amplifier. When connected, paging signal will be received in the paging area.
The non-paging signals will be output in all the other areas. If you do not connect any amplifier to this
connector, it will not be possible to output signals in any other area.
Recording connector – RCA OUT
Connect a signal source for external recording.