SERVICE
30
MAGNET POWER SUPPLY SYSTEM 8500
Following are the set up commands in alphabetic order.
Please see the SW appendix 1 for parameter formats and further detail explanation.
Esc SET UP COMMANDS. summary
Esc<AD .
. . Configures the AD converter sca-
ling and routing (Output reading
adjustment or output reading in
% or Amps).
Esc<ADR
. . Configures the communication
address setting (in RS422 mode).
Esc<ADSET . Auto Configures the scaling “gain”
and Offset for an AD converter
channel.
Esc<AUX . . Configures the special options.
Esc<AUX2 . . Configures the special options.
Esc<BAUD. . Configures the Baud rate for the
serial lines.
Esc<COLDBOOT
Configures the power up state.
(Wake up position)
Esc<DA
. . Configures The Digital to Analog
converters. (Slew rate setting in
A/sec or set value in Amps)
Esc<DASET. . Auto Configures the scaling (gain)
and Offset for a DA converter
channel.
Esc<INTERLOCK
Configures which input that has to
be latched. Other inputs will act as
status inputs.
Esc<LINE . . Configures the protocol for the
serial lines.
Esc<POLDELAY Plarity change over delay time
(in OFF).
Esc<PPULS
. Configures the ON pulse width.
Esc<PPULS1 . Auxiliary line ON pulse width.
Following are the commands for the software driven “RAMP PROFILE” listed in alphabetic order.
These commands are optionally available.
Please see the SW appendix 2 for parameter formats and further detail description.
SW RAMP PROFILE COMMANDS for “Arbitrary point method”. summary
CONT .
. . Continue sequence operation
CSS
.
. . Clear sequence stack and pointers.
FAST
.
. . Fast sequence timing
HALT .
. . Halt sequence operation
MULT .
. . Reads the multiplying factor for
DAC scaling
MULT .
. . Writes a multiplying factor for
DAC scaling
RRSP
.
. . Reset read sequence pointer
RR
Read ramp status
RSA
.
. . Read sequence and auto increment
RSP
.
. . Read sequence position
RWSP XX . . Reset write pointer.
S2
.
. . Read sequence status
SLOW .
. . Slow sequence timing
SPEED .
. . Read sequence timing
STOP
.
. . Stop sequence executing
SYNC .
. . Synchronization of sequence.
TS
.
. . Trig sequence
WSA
.
. . Write sequence and auto
increment
WSP
.
. . Write Sequence position
X is a number from 0 to 9
DANFYSIK A/S - DK 2630 TAASTRUP - DENMARK.
DOC NO P80303Sk