SERVICE
8
MAGNET POWER SUPPLY SYSTEM 8500
LINE FUNCTION PROTOCOL SETUP.
The “LINE FUNCTION PROTOCOL SETUP” is for setting up serial line protocols.
Following settings are only available from SW version SCS110
Parameters:
Dedefault setting after “COLD BOOT”
v
Remote Line:
RS485 Communication:
Disabled
(=0)
RS485 Line turn around time: 0
Line turn around set bit 0
RS485 Line turn around time: 1
Line turn around set bit 1
OK Answer mode:
Disabled
BOOT character:
"FF" / "R"
NU
Disabled
XON/XOFF Protocol:
Disabled
NU
Disabled
Local Line:
RS485 Communication:
Disabled
(=1)
RS485 Line turn around time: 0
Line turn around set bit 0
RS485 Line turn around time: 1
Line turn around set bit 1
OK Answer mode:
Disabled
BOOT character:
"FF" / "R"
NU
Disabled
XON/XOFF Protocol:
Disabled
NU
Disabled
Line turn around set bit:
2, 3: 0, 0 Delay = 0
2, 3: 0, 1 Delay = time to transmit 2 dummy characters
2, 3: 1, 0
Delay = time to transmit 4 dummy characters
2, 3: 1, 1 Delay = time to transmit 8 dummy characters
DANFYSIK A/S - DK 2630 TAASTRUP - DENMARK.
DOC NO P80303Sk
