Functions/settings
Key I (Start)
Key II (Start)
Key (Stop)
Default - Dual speed operation (connect purple
wire):
No changes to factory setting.
Run on set reference
(+/-)
Run on 10 Hz** jog
speed
Stop (and reset* - if trip)
Function 2 - Dual mode operation (connect
purple wire):
Select desired modes of operation in Setups 1
and 2 (use para. 4-6) Parameter 335 = 18 (select
Setup)
Run with Setup 1
Run with Setup 2
Stop (and reset* - if trip)
Function 3 - Dual direction operation (connect
grey wire):
Parameter 335 = 10 (start reversing) Parameter
200 = 1 (both directions)
Run forward
Run reverse
Stop (and reset* - if trip)
Table 2.25
*If no reset is required, do not connect the brown wire
**or set parameter 213
Use the [+[/[-] keys to set reference
At power up the unit will always be in stop mode. Set
reference will be stored during power down. If permanent
start mode is desired, connect terminal 6 to terminal 4 and
do not connect purple/grey wire to terminal 4. This means
the stop function on LOP is disabled.
NOTICE
After fitting, cut off or isolate excess wire.
Installation
VLT
®
DriveMotor FCM Series
MG03BA02 - VLT
®
is a registered Danfoss trademark
27
2
2
Summary of Contents for VLT Brook Crompton Motor FCM 300
Page 2: ......
Page 37: ...Programming VLT DriveMotor FCM Series MG03BA02 VLT is a registered Danfoss trademark 35 3 3...
Page 101: ...Index VLT DriveMotor FCM Series MG03BA02 VLT is a registered Danfoss trademark 99...
Page 102: ...www danfoss com drives MG03BA02 175R0087 MG03BA02 Rev 2011 12 22...
