6.1.2 Quick Menu Mode
The GLCP provides access to all parameters listed under the Quick Menus. To set parameters using the [Quick Menu] button:
Pressing [Quick Menu] the list indicates the different areas contained in the quick menu.
Efficient parameter set-up for water applications
The parameters can easily be set up for the vast majority of the water and wastewater applications only by using the
[Quick Menu]
.
The best way to set parameters using the [Quick Menu] is by following the steps below:
1.
Press [Quick Set-up] for selecting basic motor settings, ramp times, etc.
2.
Press [Function Set-ups] for setting up the required functionality of the adjustable frequency drive - if not already covered by the settings in
[Quick Set-up].
3.
Choose between
General Settings, Open-loop Settings
and
Closed-loop Settings
.
It is recommended to do the set-up in the order listed.
Figure 6.1: Quick Menu view.
Par.
Designation
[Units]
0-01
Language
1-20
Motor Power
[kW]
1-22
Motor Voltage
[V]
1-23
Motor Frequency
[Hz]
1-24
Motor Current
[A]
1-25
Motor Nominal Speed
[RPM]
3-41
Ramp 1 Ramp-up Time
[s]
3-42
Ramp 1 Ramp-down Time
[s]
4-11
Motor Speed Low Limit
[RPM]
4-13
Motor Speed High Limit
[RPM]
1-29
Automatic Motor Adaptation (AMA)
Table 6.2: Quick Set-up parameters. Please see section
Commonly Used
Parameters - Explanations
If
No Operation
is selected in terminal 27, no connection to +24 V on terminal 27 is necessary to enable start.
If
Coast Inverse
(factory default value) is selected in Terminal 27, a connection to +24V is necessary to enable start.
NOTE!
For detailed parameter descriptions, please see the following section on
Commonly Used Parameters - Explanations
.
6 How to Program the Low Harmonic Drive
VLT AQUA Low Harmonic Drive Instruction
Manual
6-2
MG.20.T1.22 - VLT
®
is a registered Danfoss trademark
6