Display lines:
a.
Status line:
Status messages displaying icons and graphics.
b.
Line 1-2:
Operator data lines displaying data and variables de-
fined or chosen by the user. By pressing the [Status] key, up to
one extra line can be added.
c.
Status line:
Status messages displaying text.
The display is divided into 3 sections:
Top section (a)
shows the status when in status mode, or up to two variables when not
in status mode and in the case of an alarm/warning.
The number of the Active Set-up (selected as the Active Set-up in par. 0-10) is shown. When programming in another set-up than the Active Set-up, the
number of the set-up being programmed appears to the right in brackets.
Middle section (b)
shows up to 5 variables with related unit, regardless of status. In the case of an alarm/warning, the warning is shown instead of the variables.
It is possible to toggle between three status read-out displays by pressing the [Status] key.
Operating variables with different formatting are shown in each status screen - see below.
Several values or measurements can be linked to each of the displayed operating variables. The values/measurements to be displayed can be defined
via par. 0-20, 0-21, 0-22, 0-23, and 0-24, which can be accessed via [QUICK MENU], "Q3 Function Set-ups", "Q3-1 General Settings", "Q3-11 Display
Settings".
Each value / measurement readout parameter selected in par. 0-20 to par. 0-24 has its own scale and number of digits after a possible decimal point.
Larger numeric values are displayed with few digits after the decimal point.
Ex.: Current readout
5.25 A; 15.2 A 105 A.
5 How to Operate the Low Harmonic Drive
VLT AQUA Low Harmonic Drive Instruction
Manual
5-2
MG.20.T1.22 - VLT
®
is a registered Danfoss trademark
5
