12-28 Store Data Values
Option:
Function:
[0]
*
Off
[1]
Store all setups
[2]
Store all setups
12-29 Store Always
Option: Function:
Activates function that always stores received
parameter data in non-volatile memory (EEPROM).
[0]
*
Off
[1]
On
8.3.4 12-5* EtherCAT
12-50 Configured Station Alias
Range:
Function:
0
*
[0 -
65535 ]
This parameter shows the configured EtherCAT
station alias for the frequency converter.
Changes are first active after a power cycle.
If the DIP switches all are set to ON or all to
OFF, the display setting has priority over the DIP
switch. Else the DIP switch settings has priority
over the parameter. In this case the parameter
will reflect the setting of the DIP switches.
Changes to the DIP switch setting, will first be
active after a power up.
12-51 Configured Station Address
Range:
Function:
0
*
[0 - 65535 ] This parameter shows the configured station
address. The parameter can only be set by the
master at power up.
12-59 EtherCAT Status
Range:
Function:
0
*
[0 -
4294967295 ]
This parameter contains status information
on the EtherCAT interface. Each of the 32
bits are linked to a status information of the
EtherCAT interface.
•
Bit 0-7 contains info from ESC
register 0x0130 (AL Status)
•
Bit 8-15 is reserved for future use
•
Bit 16-27 contains info from ESC
register 0x0110 and 0x0111 (DL
status)
•
Bit 28-31 is reserved for future use
Bit
0
1
Meaning
0
Init State
EtherCAT
Statemachine
state
12-59 EtherCAT Status
Range:
Function:
Bit
0
1
Meaning
1
Pre-OP
EtherCAT
Statemachine
state
2
Safe-OP
EtherCAT
Statemachine
state
3
Operation
al
EtherCAT
Statemachine
state
4
Reserved
5
Reserved
6
Reserved
7
Reserved
8
Reserved
9
Reserved
10
Reserved
11
Reserved
12
Reserved
13
Reserved
14
Reserved
15
Reserved
16 EEPROM
not
loaded,
PDI not
operation
al
EEPROM
loaded
correctly,
PDI
operation
al
PDI
Operational
17 Watchdog
expired
Watchdog
reloaded
PDI Watchdog
Status
18 Deactivate
d for all
ports
Activated
for all
ports
Enhanced link
detection
19
Reserved
20 No link
Link
detected
Physical link
on Port 0
21 No link
Link
detected
Physical link
on Port 1
22
Reserved
23
Reserved
24 Open
Closed
Loop port 0
25 No stable
communi-
cation
Communi-
cation
establishe
d
Communi-
cation on port
0
26 Open
Closed
Loop port 1
27 No stable
communi-
cation
Communi-
cation
establishe
d
Communi-
cation on port
1
28
Reserved
29
Reserved
30
Reserved
Parameters
MCA 124 EtherCAT Operating Instruction
38
MG92A302 - VLT
®
is a registered Danfoss trademark
8
8