Service guide
|
Disassembling and Assembling, iSave 50-70
© Danfoss | DCS (im) | 2016.10
180R9387 | 521B1430 | DKCFN.PI.013.1H.02 | 7
18. Carefully lift out the rotor (make sure the
pins do not drop out and that the vanes
do not get damaged).
17. Mount the M8 lifting eye in the rotor
shaft end.
19. Remove the rotor elements in the rotor
using the small screwdriver in the 2
small cut outs in the rotor.
20. Remove by hand the rotor elements
and check and replace the rotor elements
if necessary.
Always change rotor stops and side
plates at the same time as changing the
rotor elements.
21. Lubricate the rotor elements, rotor and ‘
O-ring with clean filtered water.
Replace the O-ring in the rotor elements.
Make sure not to damage or twist the
O-rings.
22.Mount the rotor elements by hand, by
carefully pushing them into the rotor.
Make sure not to damage or twist the
O-rings.
