Danfoss FC 300, Manual

Page: 47 / 61

FC 300 CANopen
MG.33.J1.02 VER. 050301 – VLT is a registered Danfoss trademark
47
Option:
Digital input [0]
Bus [1]
Logic AND [2]
*Logic OR [3]
Function:
Choose between controlling the drive via the
terminals (digital input) and/or via the bus.
If you select
Bus
, you can only activate the Start
command if it is transmitted via the serial
communication port or fieldbus option. If you
select
Logic AND
, you must also activate the
command via one of the digital inputs. If you
select
Logic OR
, you can also activate the Start
command via one of the digital inputs.
NB! This parameter is active only when
par. 8-01 Control site is set to [0] Digital and
control word.
8-54 Reversing Select
Option:
Digital input [0]
Bus [1]
Logic AND [2]
*Logic OR [3]
Function:
Choose between controlling the drive via the
terminals (digital input) and/or via the bus.
If you select
Bus
, you can only activate the
Reversing command if it is transmitted via the
serial communication port or fieldbus option. If
you select
Logic AND
, you must also activate the
command via one of the digital inputs. If you
select
Logic OR
, you can also activate the
Reversing command via one of the
digital inputs.
NB! This parameter is active only when
par. 8-01 Control site is set to [0] Digital and
control word.
8-55 Set-up Select
Option:
Digital input [0]
Bus [1]
Logic AND [2]
*Logic OR [3]
Function:
Choose between controlling the drive via the
terminals (digital input) and/or via the bus.
If you select
Bus
, you can only activate Selection
of Setup if it is transmitted via the serial
communication port or fieldbus option. If you
select
Logic AND
, you must also activate the
command via one of the digital inputs. If you
select
Logic OR
, you can also activate the Set-up
command via one of the digital inputs.
NB! This parameter is active only when par.
8-01 Control site is set to [0] Digital and
control word.
8-56 Preset Reference Select
Option:
Digital input [0]
Bus [1]
Logic AND [2]
*Logic OR [3]
Function:
Choose between controlling the drive via the
terminals (digital input) and/or via the bus.
If you select
Bus
, you can only activate the Preset
Reference command if it is transmitted via the
serial communication port or fieldbus option. If
you select
Logic AND
, you must also activate the
command via one of the digital inputs. If you
select
Logic OR
, you can also activate the Preset
Reference command via one of the digital inputs.
NB! This parameter is active only when
par. 8-01 Control site is set to [0] Digital and
control word.
8-90 Bus Jog 1 Speed
Option:
0 – par. 4-13 RPM * 100 RPM
Function:
Sets a fixed speed (jog) activated via the serial
port or bus option.
8-91 Bus Jog 2 Speed
Option:
0 – par. 4-13 RPM * 200 RPM
Function:
Sets a fixed speed (jog) activated via the serial
port or bus option.
10-00 CAN Protocol
Option:
Read only from LCP.
*CANopen [0]
Function:
Indicates the CAN protocol.