Telco / Digital Module
AirMax from D&R - Phone: +31 294 418014 - E-Mail:
- 18 -
8 TELCO/DIGITAL
Module
SEND
The SEND control adjusts the outgoing signal level at the SEND A and SEND B outputs.
GAIN
The GAIN control adjusts the incoming signal level on LINE A and LINE B.
INPUT
The INPUT switch allows the user to switch input between LINE A and LINE B.
The associated LEDS indicate which input is currently selected.
MONO
The MONO switch can be used to make an incoming signal mono or accept one and route
it to both outputs of the module. The associated LEDS indicate if the mono switch is
currently active and if either left and right inputs are summed, only the left input signal is
routed through, or only the right.
HF
Adjusts high frequencies with +/- 12 or +/-6 dB at 10 kHz shelving.
MF
Adjusts high-mid frequencies with +/- 12 or +/-6 dB at 1 kHz bell curve.
LF
Adjusts the low frequencies with +/- 12 or +/-6 dB at 60 Hz shelving.
EQ
The EQ led indicates whether equalization is on or off.
GROUPS
These leds indicate if and to which stereo GROUP this module is assigned.
PROG
The PROG switch assigns the signal in stereo to the PROG output.
SUB
The SUB switch assigns the signal in stereo to the SUB output.
AUX1
The AUX1 control adjusts the amount of signal sent to the stereo AUX 1 bus.
AUX2
The AUX2 control adjusts the amount of signal sent to the stereo AUX 2 bus.
PAN
Allows adjustment between the left and right channel outputs.
COMM
The COMM switch enables communication between this channel and anyone who has
access to the COMM bus at the same time.
VCA
These leds indicate if and by which VCA master this module is currently controlled.
The VCA led gives an indication of the amplitude of the VCA control voltage.
