Dugan Models E-1 and E-1A User Guide
Installation and Configuration
25
Manually Add Unit
If the Dugan unit does not appear in the Dugan Utility list pane, you can manually
add the unit:
1.
Power down the Model E-1A.
2.
Hold down Channel 1’s
mute
button and power up the unit.
This performs a network reset.
3.
Click
Manually Add Unit
.
4.
Enter the default IP address: 192.168.1.xx
xx = last two digits of serial number, unless they are 00, in which case enter 100.
5.
Click OK to exit the dialog.
6.
Click
Refresh List
.
If the list pane is still blank, see
Using the Internally Stored Dugan Control Panel
on
page 25.
Using the Internally Stored Dugan Control Panel
Normally, the Dugan Control Panel is run from the
Dugan-Control-Panel-
vxxx
.jar
file. However, if for any reason you do not have that file or an Internet connection,
you can run the Dugan Control Panel from a copy stored in the unit (see Chapter 6:
Updates
).
It is not currently possible to run the internally stored Dugan Control Panel from an iPad.
To run the internally stored Dugan Control Panel:
1.
Launch your browser.
2.
Enter the IP Address of the unit.
If you do not know the IP Address, see
Network Reset
to set it to a known address.
3.
Since the Top Pane will be empty, open a separate browser tab for each unit you
wish to operate and enter its IP Address.
If this does not work, consult the
duganusers
Yahoo group (
http://tech.groups.ya-
hoo.com/group/duganusers
) or contact Dan.
iPad
Summary of Contents for E-1
