Serie "LXS9"
Pagina A - 18
Rev. M - 01
If errors should be detected during the check, the check itself stops and the following message appears:
Where “
xxxxxx
” is the detected error. See the “
Installation and service
” manual, "
Problems and relative
solutions
” chapter, “
Motor anomaly messages
” section for the list of anomalies and relative solutions.
From these error conditions it is possible to make the check sequence continue by pressing the
F
key, or
end it with the
A
key.
One of the following messages will appear at the end of the check sequence:
This means that anomalies and/or differences between the current configuration and the one detected
during the last self-learning procedure have been detected; XX indicates the number of the currently
recognised motors.
This means instead that anomalies and/or differences between the current configuration and the one
detected during the self-learning procedure have not been detected; XX indicates the number of the
recognised motors.
In the e
vent of “Check OK”, at the end of the motor check cycle the vending machine‟s original
configuration is completely restored and the out of orders reset.
N.B.: at each check the motors rotate just a few degrees; therefore, repeating the check several times in
succession, the motors could lose alignment; we therefore recommend realigning the motors, for example
by carrying out a manual motor test, as described previously in this manual.
>
M
OTOR SELF
-
LEARNING
:
Select this item to repeat the self-learning of the motors present in the vending machine; this action is only
allowed if a password is set in the protected parameters menu.
Check OK
Conn. motors: XX
Check incorrect
Conn. motors: XX
Error
xxxxxx
Programming
Diagnostics
Motor Slearning
->->->->
Self-learning
Conn. motors: xx
F
F
Summary of Contents for LXS9 Series
Page 2: ...Serie LXS9 Pagina A 25 Rev M 01...
Page 22: ...Serie LXS9 Page 21 Rev M 01...
