damian LXS9 Series Installation And Service Download Page 13

Page: 13 / 46

Serie "LXS9"

Page 12

Rev. M - 01

Message

code

Message text

Problem description / solution

OFF L13… Sliding anti-theft panel errors.

These error messages concern failures of the sliding anti-theft panel

(10) closing/opening system.

OFF L13a

Sliding Panel

(S.D. Mot. Fault) - Sliding panel motor short-circuited

- Check the operation of the sliding panel motor (11) and the relative wiring; replace

it if necessary.

OFF L13b

(SD Mot. Disconn.) -

Sliding panel motor disconnected

- You are attempting to make the sliding panel motor work with the door open when

the open door switch (12) is not activated. Close the door or arm the switch to
simulate the closed door.

- If the door is closed, check the operation of the door open switch (12) and the

relative wiring. Also check that the bracket (14) that presses the switch is adjusted
properly. Replace the switch if necessary.

- Check the motor (11) of the sliding panel (10) and the relative wiring. Replace it if

necessary.

OFF L13c

(Sl.Door Removed) - Sliding panel removed

Neither of the 2 beginning/end stroke microswitches (13) located near the motor are
pressed.
- Check that the sliding panel has been put back on after maintenance.
- Check the operation of the 2 beginning/end stroke microswitches (13) and the

relative wiring. Replace them if necessary.

OFF L13d

(Switch Exchanged) - Sliding panel microswitches inverted

The CPU card (2) receives the closing signal when the motor (11) opens the sliding
door (10) and vice versa.
- Check that the beginning/end stroke microswitches (13) have been connected

correctly after maintenance.

- Check that the panel motor (11) power supply connection has not been inverted.

OFF L13e

(TimeOut SD Mot.) - Sliding panel error during opening

At the end of an opening cycle, the sliding panel does not open completely or is not
detected to be open.
- Check that the sliding panel (10) can slide freely, that the guides are clean and that

there is nothing preventing complete opening.

- Check the operation of the opening microswitch (13) and the relative wiring.

Replace it if necessary.

OFF L13f

(TimeOut SD Mot.) - Sliding panel error during closing

At the end of an opening / closing cycle, the sliding panel does not close completely
or is not detected to be closed.
- Check that the sliding panel (10) can slide freely, that the guides are clean and that

there is nothing preventing complete closing.

- Check the operation of the closing microswitch (13) and the relative wiring.

Replace it if necessary.

OFF L13g

(SD Mot Movement)

– Sliding panel motor movement error

You  are  trying  to  make  the  sliding  panel  (10)  work  but  the  motor  (11)  idles  or  is
blocked.
-  Check that the motor block of the panel is hooked correctly.
-  Check that the motor gear (11) works correctly.

- Check that the sliding panel (10) can slide freely.

OFF L20… CL1 CPU (2) circuit board errors.

These error messages concern failures of the

vending

machine

‟s circuit board.

OFF L20a

OFF L20b

CL1 CPU Error

(Restart - Change) - CPU card error

- Turn the vending machine off and then on again; if the problem persists, replace

the CPU card (2).