Serie "LXS9"
Pagina A - 2
Rev. M - 01
PROGRAMMING METHOD
T
O ENTER INTO PROGRAMMING
Open the vending machine, power it up using the special key on the safety switch and press the pushbutton
(P) found on the CPU card of the vending machine (see the above figure) for about 2 seconds; avoid
reclosing the vending machine so as not to damage the safety switch.
When the safety switch is armed with the special key, do not perform any operations other
than those described.
T
O CHOOSE THE PARAMETER THAT YOU WISH TO PROGRAMME
Select the menu using keys
D
(
A
)
or
E
(
C
)
, the messages relative to the various menus will appear on the
second line of the display.
When the message relative to the desired menu appears, press the
F
(
Enter
)
key to confirm.
The parameter name will appear on the first line of the display, the currently set value on the second line.
Select the menu parameter using the
D
(
A
)
or
E
(
C
)
keys; the messages relative to the various menu
parameters will appear in sequence on the first line of the display, until it starts again from the first
parameter.
When the message relative to the desired parameter appears, press the
F
(
Enter)
key to confirm.
T
O CHANGE THE PROGRAMMED VALUE OF THE SELECTED PARAMETER
If “***>” appears on the second line followed by the current value.
Using the keyboard, write the desired value or press the
D
(
A
)
key to increase or the
E
(
C
)
key to decrease
the current value.
Press the
F
(
Enter
)
key to confirm and return to the previous point or press the
A
(
Esc
)
key to exit typing
without modifying the previous value.
Press the
C
(
D
)
key to reset the proposed number.
In some cases press the
C
(
D
)
key to move one digit to the left, until starting again from the first on the
right. Once all of the digits have been entered, press the
F
(
Enter
) key to confirm and return to the previous
point or press the
A
(
Esc
)
key to exit typing without modifying the previous value.
T
O EXIT PROGRAMMING
Press the
A
(
Esc
)
key to return to the selection of the menus.
Press the “Programming key” (
P
) found on the CPU card of the vending machine for about 4 seconds or
press the
A
(
Esc
)
key for a few seconds.
In any case, if no key is pressed for more than 120 seconds you will automatically exit the programming
phase.
1
(P) Programming key
PS2 key
Esc
Enter
PS2
Summary of Contents for LXS9 Series
Page 2: ...Serie LXS9 Pagina A 25 Rev M 01...
Page 22: ...Serie LXS9 Page 21 Rev M 01...
