Dalsa P3-80-**k40-R, User Manual

Page: 80 / 91

Piranha 3 User Manual
03-032-10216-02 DALSA
80
Command Syntax Parameters Description
get line average
gla x1 x2
Read the average of line samples.
x1
= Pixel start number
x2
= Pixel end number
in a range from
1
to
sensor pixel
count
.
Refer to Returning Averaged Lines of
Video on page 45 for details.
get prnu coeff
gpc i
Read the PRNU coefficient.
i
= pixel number to read in a range from
1 to sensor pixel count.
Refer to Returning Calibration Results
and Errors on page 49 for details.
get signal frequency
gsf i
Read the current sync frequency.
1
: CC1 (EXSYNC)
2
: CC2 (PRIN)
3
: CC3 (Spare)
4
: CC4 (Spare)
Refer to section 3.6.5 Camera Frequency
Measurement for details.
get sensor serial
gss
Read the sensor serial number
help
h
Display the online help. Refer to on page
24 for details.
load pixel coefficients
lpc i
Loads the previously saved pixel
coefficients from non-volatile memory
where
i
is:
0
= Factory calibrated coefficients
1
= Coefficient set one
2
= Coefficient set two
3
= Coefficient set three
4
= Coefficient set four
Refer to 3.5.1 Saving and Restoring
PRNU and FPN Coefficients for details.
reset camera
rc
Reset the entire camera (reboot).
restore factory settings
rfs
Restore the camera’s factory settings.
FPN and PRNU coefficients reset to 0.
Refer to section 3.5 Saving and Restoring
Settings for details.
region of interest
roi x1 y1 x2
y2
Sets the pixel range affected by the cag,
cao, gl, gla, ccf, and ccp commands. The
parameters are the pixel start and end
values (x) and the column start and end
values (y) in a range from 1 to sensor
pixel count. Refer to section 3.4.1 Setting
a Region of Interest (ROI) for details.
reset pixel coeffs
rpc
Reset the pixel coefficients to 0. Refer to
Resetting the Current Pixel Coefficients
on page 53 for details.
restore user settings
rus
Restore the camera's last saved user
settings and FPN and PRNU coefficients.
Refer to section 3.5 Saving and Restoring
Settings for details.