Dalsa P3-80-**k40-R, User Manual

Page: 75 / 91

Piranha 3 User Manual
DALSA 03-032-10216-02
75
Appendix B
Error Handling and
Command List
B1 Error Handling
The following table lists warning and error messages and provides a description and
possible cause.
Table 16: Warning and Error Messages
Message Description
OK> SUCCESS
Warning 01: Outside
of specification> Parameter accepted was outside of specified operating range (e.g.
gain greater than ±10 dB of factory setting).
Warning 02: Clipped
to min> Parameter was clipped to the current operating range. Use GCP to
see value used.
Warning 03: Clipped
to max> Parameter was clipped to the current operating range. Use GCP to
see value used.
Warning 04: Related
parameters
adjusted> Parameter was clipped to the current operating range. Use GCP to
see value used.
Warning 05: Missing
codes – insufficient
digital gain> Output when the digital gain is such that missing codes are to be
expected due to not enough digital gain.
Warning 06: Missing
codes – too much
digital gain> Output when the digital gain is such that missing codes are to be
expected due to too much digital gain.
Warning 07:
Coefficient may be
inaccurate A/D
clipping has
occurred> In the region of interest (ROI) greater than 6.251% single or 1% of
averaged pixel values were zero or saturated.
Warning 08: Greater
than 1% of
coefficients have
been clipped A FPN/PRNU has been calculated to be greater than the maximum
allowable 511 (8).
Message Description
Error 01: Internal
error xx> Output only in “diagnostic mode” or self check at power or reset
camera. Where xx is a code.