Dalsa Genie Nano-5G Series, User Manual, Page: 93 / 204

Nano-5G Series GigE Vision Camera Operational Reference • 91
Cycling Preset Mode Control Category
The Genie Nano-5G Cycling Preset controls, as shown by CamExpert, has parameters used to
configure the camera Cycling features. Cycling controls allow the user to configure a number of
camera operational states and then have the camera automatically switch between states in real-
time. Only the features programmed to change are updated when switching between camera
states, thus ensuring immediate camera response. A setup example follows the feature table.
Parameters in gray are read only, either always or due to another parameter being disabled.
Parameters in black are user set in CamExpert or programmable via an imaging application
Features listed in the description table but tagged as
Invisible are usually for Teledyne DALSA or
third party software usage — not typically needed by end user applications. Also important, Genie
Nano-5G cameras are available in a number of models implementing different sensors and image
resolutions which may not support the full feature set defined in this category.