Dalsa Genie Nano-5G Series, User Manual

Page: 67 / 204

Nano-5G Series GigE Vision Camera Operational Reference • 65
Output Line Value outputLineValue Sets the output state of the selected Line if the
outputLineSoftwareLatchControl = OFF. OutputLineSource
must be SoftwareControlled. If the
outputLineSoftwareLatchControl = Latch , the state of the
pin will change with the outputLineSoftwareCmd
command.
1.00
Beginner
DFNC
Active Active Sets the Output circuit to close
Inactive Inactive Sets the Output circuit to open
Output Line Software Latch
Control outputLineSoftwareLatchControl When Off, the selected output line is set with the value in
Output Line Value.
1.00
Guru
DFNC
Off Off Output pin state set by outputLineValue.
Latch Latch Output pin state set by outputLineSoftwareCmd.
Line Status All LineStatusAll Returns the current status of all available line signals, at
time of polling, in a single bitfield. The order is Line1,
Line2, Line3, ...
1.00
Expert
Output Line Software
Command outputLineSoftwareCmd Writing a value of 1 in the bit field applies the Latch value
of the outputLineSoftwareLatchControl and/or executes
the PulseOnSoftwareCmd for any output line programmed
for software control. The feature outputLineSoftwareCmd
can take any binary value and each bit set to 1
corresponds to a Icommand for an Output. Note that
Outputs are numbered from 1 to N, therefore Bit 1 of
outputLineSoftwareCmd corresponds to Output1. This is
applicable to OutputLineSource = Pulse On: where
Software Cmd (for Pulse mode) or OutputLineSource =
SoftwareControlled and OutputLineSoftwareLatchControl
= Latch (for static states).
1.00
Expert
DFNC
Line Pinout linePinAssociation Enumeration of the physical line (or pin) on the device I/O
connector. (RO)
1.00
Invisible
Pin5=Signal – Pin3=Gnd Pin5Signal_Pin3Gnd Pin 5 is the Input Signal and Pin 3 is the common input
Ground on the I/O connector.
Pin7=Signal – Pin3=Gnd Pin7Signal_Pin3Gnd Pin 7 is the Input Signal and Pin 3 is the common input
Ground on the I/O connector.
Pin6=Signal – Pin4=Pwr Pin6Signal_Pin4Pwr Pin 6 is the Output Signal and Pin 4 is the common output
Power on the device connector.
Pin8=Signal – Pin4=Pwr Pin8Signal_Pin4Pwr Pin 8 is the Output2 Signal and Pin 4 is the common
output Power on the device connector.