Dalsa Genie Nano-5G Series, User Manual

Page: 65 / 204

Nano-5G Series GigE Vision Camera Operational Reference • 63
ReadOut ReadOut Trigger is accepted immediately after the start of the
readout.
End Of Exposure EndOfExposure Trigger is accepted immediately after the previous
exposure period. This will latch the Trigger and delay the
Exposure if the end of that exposure is shorter than the
previous readout.
Trigger Delay (in µ s) TriggerDelay Specifies the delay in microseconds to apply after
receiving the trigger and before activating the
triggerEvent. (min=0, max=2000000)
1.00
Beginner
Line Selector LineSelector Selects the physical line (or pin) of the external device
connector to configure.
1.00
Beginner
Line 1 Line1 Index of the physical line and associated I/O control block
to use. Pin 5 is the Input Signal and Pin 3 is the common
Ground on the I/O connector.
Line 2 Line2 Index of the physical line and associated I/O control block
to use. Pin 7 is the Input Signal and Pin 3 is the common
Ground on the I/O connector.
Line 3 Line3 Index of the physical line and associated I/O control block
to use. Pin 6 is the Output Signal and Pin 4 is the common
output power on the I/O connector.
Line 4 Line4 Index of the physical line and associated I/O control block
to use. Pin 8 is the Output Signal and Pin 4 is the common
output power on the I/O connector.
Line 5 Line5 Index of the physical line and associated I/O control block
to use. Pin 9 is the Output Signal and Pin 4 is the common
output power on the I/O connector.
Line Name lineName Description of the physical Pin associated with the logical
line.
1.00
Beginner
DFNC
Input 1
Input 2 Input1
Input2 Associated with the logical line Input 1
Associated with the logical line Input 2
Output 1
Output 2
Output 3
Output1
Output2
Output3
Associated with the logical line Output 1
Associated with the logical line Output 2
Associated with the logical line Output 2
Line Format LineFormat Specify the current electrical format of the selected
physical input or output. (RO)
1.00
Expert
Opto-Coupled OptoCoupled The line is opto-Coupled.
Line Mode LineMode Reports if the physical Line is an Input or Output signal.
(RO)
See Input Signals Electrical Specifications.
See Output Signals Electrical Specifications.
1.00
Expert
Input Input The line is an input line.
Output Output The line is an output line.
Line Status LineStatus Returns the current status of the selected input or output
line.
1.00
Expert
False The Line is logic LOW
True The Line is logic HIGH
Line Inverter LineInverter Control to invert the polarity of the selected input or
output line signal.
1.00
Beginner
False / True