[8]
MAN #650793
Locating sensors on a VFD3 or VFD3X system:
From Step 19:
SKIP
and
are displayed.
Tap SW1 (I) once to change the display to
BEGIN
and
.
Press and hold SW1 (I) to change the display to
FILL LO
and
-
. 2
nd
display =
TIRES
.
o
Release may show
X
(number of tires)
TIRES
and
. 2
nd
display =
FILL LO
.
o
A single message center will alternate between
X TIRES
and
FILL LO
.
o
The
FILL LO
message appears is because the sensors are not awake.
o
Driving the car a few minutes before doing the location process will awaken the sensors.
o
Deflating and inflating the tires could awaken sensors.
o
The VFD cannot display which sensor is low.
If the sensors are awake the display would show
DEFLATE
and
. 2
nd
display =
LF TIRE
.
o
A single massage center will alternate between
DEFLATE
and
LF TIRE
.
Deflate that corner tire by only a few PSI, and wait a minute for the sensor to see the change.
o
If the car has been stationary for more than 15 minutes, it will take 60 seconds to see changes.
o
If the car was driven 5-10 minutes before starting Locate, the response time will be 5 seconds.
When the LF sensor see a pressure drop
DEFLATE
and LOC. 2
nd
display
RF TIRE
will display.
o
A single massage center will alternate between
DEFLATE
and
RF TIRE
.
When the RF sensor see a pressure drop
DEFLATE
and LOC. 2
nd
display
LR TIRE
will display.
o
A single massage center will alternate between
DEFLATE
and L
R TIRE
.
When the RF sensor see a pressure drop
FILL LO
will display.
o
Fill the three tires back up to normal operating pressure.
o
The RR rear will not need to be deflated.
Tap SW1 (I) once to display
DONE
and
.
Press and hold SW1 (I) to display
DONE
and
-
to exit
Summary of Contents for BIM-22-3
Page 15: ...15 MAN 650793 NOTES...
