CUT 250 COLD SAW
7/13/05
12
Off position
ON position
-Be sure that the blade is rotating in the correct direction indicated (the blade will rotate clock
wise, be sure the blade is on correctly, also see changing the blade page 12) and check to make
sure the coolant is on.
-The machine is now ready to cut the material. Keep in mind that the cutting speed and the type of
blade, combined with a suitable descent of the head are of decisive importance for cutting quality
and machine performance.
- When starting to cut with a new blade, be sure to take out the back lash (see changing the blade)
on the blade, in order to safeguard the blade life and efficiency, the first two or three cuts must be
made while exerting a slight pressure on the part, so that the time taken to cut is about double the
normal time. Grip the handle and press the button, slowly move the head in the down position and
begin to cut the material. When you are done cutting the material, release the blade “on button”
and move the head in the up position.
Changing the blade
Warning!!!!!
Before performing the following operations, the electrical supply must be
LOCKED OUT.
Illustration 20
-Move the head to the upright position and remove the blue safety guard bolt (5mm Allen wrench
see illustration 20), move the safety guard in the back position.
Safety guard
Bolt holding
safety guard
Blade bolt
10mm Allen wrench
5mm Allen wrench
6mm Allen wrench
Summary of Contents for CUT 250 COLD SAW
Page 19: ...CUT 250 COLD SAW 7 13 05 19...
Page 20: ...CUT 250 COLD SAW 7 13 05 20...
