DAINIPPON SCREEN PLATE RITE 4300, User Manual

Page: 54 / 167

PT-R4300 USERS MANUAL
4-16
5. Check the plate data and printing machine data that appears in the screen, and
then press
[LOAD]
. The system begins loading the next plate.
If the plate data in the screen differs from the plate inserted, press
[Plate]
to
open the plate selection screen, select the same plate data as the inserted plate,
and then press
[OK]
. To change the printing machine data, press
[Printing]
to
open the printing machine information setting screen, select the printing machine
data to be used, and then press
[LOAD] .
After punching, the loaded plate waits in standby until the completion of
exposure of the previously set plate.
8.3 Set Next Plate while Exposure is in Progress
Insertion and ejection of plates is performed on the PT-R using separate insertion and
ejection tables, and thus it is possible to set the next plate on the insertion table while
exposure is in progress. When this is done, the next plate waits on standby until
exposure is completed. When exposure is completed and the exposed plate is ejected
to the ejection table, the plate that was on standby is loaded and waits for the
exposure instruction from the host computer.
By ejecting the exposed plates during exposure, the next plate can be set and the
waiting time for ejecting and setting is minimized. This is recommended to increase
productivity with the PT-R.
1.
When plate loading is completed,
[OPEN]
will appear in the online screen.
Press [OPEN] . The lock is released and the operation door slightly opens.
2. Place the plate on the insertion table and peel off the interleaf paper.
3.
Align the plate on the gradations corresponding to the size of the plate on the left
and right positioning labels, and push the plate in until it touches the shutter
inside the transport.
4.
Close the operation door by hand until it locks. The plate loading screen will
display.
Fig. 4-23 Plate loading screen
LOAD
Plate
Printing
OPEN
1 Plate 1
Printing machine 1
Confirm setting and correct if necessary.
Then press [LOAD].