DAINIPPON SCREEN PLATE RITE 4300, User Manual

Page: 89 / 167

5-29
Chapter 5 User Menu
5. Setting the Exposure Conditions
Set the plate ejection method for output, and select mirror output, positive/negative
output, and exposure conditions for the layout method.
1. Select [Set exposure mode] in the offline screen and press [OK] . The
ejection method selection screen appears. (If an online processor is not
connected, the exposure condition setting screen (Fig. 5-37) will appear instead
of the ejection method selection screen.)
Fig. 5-36 Ejection method selection screen
Fig. 5-37 Exposure condition setting screen
OK ESC
Processor/
Manual
SAVE ESC
Mirror
Posi/Nega
Layout
1 1 2 3
: Eject an exposed plate from the rear outlet of the PT-R (if an online
processor is connected, the plate will pass through the online
processor).
: Eject an exposed plate to the PT-R’s ejection table.
2.
Select the ejection method and press
[OK]
. The exposure condition setting
screen appears.
Mirror: Posi/Nega:
: Not mirror output : Positive output
: Mirror output : Negative output
CAUTION
!
• Do not perform mirror output. When exposure takes place in mirror output
mode, spiral correction is reversed, producing a skewed image.
• Do not set negative output (exposure condition) for a positive plate. If a
negative output setting (exposure condition) is used for output on a
positive plate, exposure remnants may occur on the burn out edges. If
negative output is necessary, use the RIP invert function.