ATXS20/25/35/42/50G2V1B
SiENBE04-808_A
93
System Configuration
ATTENTION
To use ON TIMER operation
•
Check that the clock is correct.
If not, set the clock to the present time.
1. Press “ON TIMER button”.
•
“
6:00
” is displayed on the LCD.
•
“
” blinks.
2. Press “TIMER Setting button” until the time
setting reaches the point you like.
•
Every pressing of either button increases or
decreases the time setting by 10 minutes.
Holding down either button changes the
setting rapidly.
3. Press “ON TIMER button” again.
•
The TIMER lamp lights up.
To cancel the ON TIMER operation
4. Press “CANCEL button”.
•
The timer lamp goes off.
To combine ON TIMER and OFF TIMER
•
A sample setting for combining the two timers is shown below.
In the following cases, set the timer again.
•
After a breaker has turned off.
•
After a power failure.
•
After replacing batteries in the remote control.
2
1, 3
4
(Example)
Present time: 11:00 p.m.
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
Combined
SiENBE04-808_A.pdf 105
21/02/2011 13:20:01