11
Preparation before Operation
Installation of the unit
Installed on a table or the
fl
oor
100cm from ceiling
50cm from wall
50cm from wall
Air
fl
ow
10cm from wall
The wall where the air puri
fi
er is set may get dirty depending on
•
the type of wall and environment, even if you follow the
speci
fi
ed dimensions of left. In such cases, move the unit a
safe distance away from the wall.
If the air puri
fi
er is used for a long time at the same location,
•
the bottom of the unit and
fl
oor may become dirty due to the
suction air
fl
ow from the bottom of the unit. Periodic cleaning is
recommended.
CAUTION
ATTENTION
The air is blown slightly to the right, but nothing is wrong with the
•
unit.
Select a location which allows the air to reach the entire room.
•
Place the air puri
fi
er on a
fl
at area where it is stable. If the
fl
oor is
•
uneven, the unit may vibrate excessively.
Hints for smart installation
To remove house dust, it is effective to install the unit at a lower position in the room. To
•
remove cigarette smoke, it is effective to install the unit in a higher part of the room.
If you install the air puri
fi
er opposite the air conditioner, the circulation effect is enhanced.
•
The unit controls unevenness in the room temperature while cleaning the air during
heating or cooling operation.
Keep TVs, radios and stereos 2m or more away from the unit.
•
(The effects of the power circuit inside the unit and cable may cause a distorted TV
picture or noise.)
Keep cordless phones or atomic radio clocks away from this unit also.
Air
fl
ow
Do not use the unit in the following places.
Do not use the unit in a location exposed to direct sunlight.
•
(The response of the main unit to the signal from the remote controller may be weakened and the colour may change.)
Do not use the unit in locations of high temperature.
•
(Heat may discolour and deform the unit.)
Exposed to soot (conductive dust) generated by candles, aromatic candles, etc.
•
The operating ef
fi
ciency of the
fi
lter may be lowered, and the room may become dirty due to dust that is not collected.
Near to a
fi
re alarm
•
If the air from the outlet is blown toward a
fi
re alarm, the alarm may respond late or it may not respond.
Do not use cosmetics, etc. combined with silicone near the unit.
•
*Cosmetics, antiperspirant, antistatic agent, waterproof spray, spray polish, glass cleaner, chemical wiping cloths, wax, and hair care
products (split ends coating agent, hair mousse, and hair conditioner).
Insulators such as silicone may adhere to the needle of the streamer unit, and a streamer may not be generated. In this case, clean
UNIT2.
Page 20.
►
01_EN_3P276413-2C.indd 11
01_EN_3P276413-2C.indd 11
9/27/2011 1:20:17 PM
9/27/2011 1:20:17 PM
