UNIT1
(Plasma ioniser)
UNIT2
(Streamer unit)
* Remove dirt from recesses
with a cotton swab, etc.
Wear rubber
gloves.
19
Cleaning of UNIT1 and UNIT2
Time for
cleaning
UNIT1:
If the “UNIT1” lamp lights
UNIT2:
Once every 3 months or if
the “UNIT2” lamp lights
Cleaning
method
Soak, drain and dry
Wipe
If marking is a concern, clean the unit even if the “UNIT1” and “UNIT2”
lamps do not light.
For details on removing and attaching each part,
see
Page 17.
►
.
Ionising frame
Streamer unit
Ionised wire (rear)
Opposing pole
plates
Procedure
UNIT1
Ionising frame / Ionised wire
Opposing pole plates
Remove the parts.
Page 9.
►
Page 17, 18.
►
Page 18.
►
Use a vacuum cleaner to remove the
dust.
Soak in lukewarm water or water.
(About 1 hour)
Remove dirt with a piece of cloth, soft
brush, etc.
Wear rubber
gloves.
Cloth
Cotton
swab
For details,
1) Ionising frame
2) Ionised wire
Wear rubber gloves.
Wipe
Brush
Cloth
Rub
Wear rubber gloves.
Rinse in running water and drain.
Dry in a well-ventilated, shaded
place. (About 1 day)
Attach the parts.
Page 10.
►
Page 17, 18.
►
Page 18.
►
1) Ionising frame
(Remove dirt after soaking
but before drying.)
Remove dirt from plastic
•
parts with a soft piece of
cloth.
Use a cotton swab, etc. to
•
wipe away dirt in recesses
and places where
fi
ngers do
not
fi
t.
Do not leave any lint from
•
cleaning cloths behind. Lint
may lead to malfunctions.
2) Ionised wire
(8 locations)
Remove dirt from the ionised wires and
•
surrounding plastic parts with a soft
piece of cloth.
* Wipe ionized wires gently.
Pulling on them forcefully may cause
them to snap.
Wear rubber
gloves.
01_EN_3P276413-2C.indd 19
01_EN_3P276413-2C.indd 19
9/27/2011 1:20:47 PM
9/27/2011 1:20:47 PM